Normal Mistakes usually Made During Wheel Hub Assembly Replacement
Mistakes made during wheel hub assembly replacement can create rework and loss for you and cause your customers a myriad of inconveniences, so it is important to prevent errors before they occur. Three common mistakes made during replacement include not testing the wheel hubs thoroughly after replacement, not torquing units properly into place and not using high-quality replacement parts. Avoiding these mistakes will make a world of difference in the service you provide to customers.
Forget to test Wheel Hubs
take the hub bearing 43550-42010 for example!
It’s important to test wheel hubs thoroughly after replacement, because there are a number of things that can go wrong installing new units. Although you can rotate the tire after you’ve put the wheel components back together, it’s better to perform tests on the wheel hub itself. You can rotate the unit by hand and use a measurement tool to detect slight variations in the unit’s rotation. Although it’s tempting to re-install the braking unit quickly and remount the tire, performing tests can save you and your customers from rework and delays.
Not Torque Units
Tightening wheel hubs into place is important, because the amount of torque used ultimately affects a unit’s performance. Some technicians make the mistake of not using a torque wrench to ensure there is a tight fit once the unit is in place. Oftentimes, it’s a forgotten step, especially if technicians are busy and they’re under stress. Keeping a torque wrench close by during replacement jobs will keep your customers’ vehicles on the road and out of your shop.
Not check the quality before using
Some shops opt for lower quality wheel hub assemblies, which cost less to stock and offer short-term gains. However, these types of units are likely to hurt a vehicle’s performance, which is sure to disappoint customers and keep them from coming back for repeat service. Instead, it’s better to use original equipment quality parts that can withstand tough terrain and varying climate conditions. You and your customers stand to gain from using high-quality parts.
Replacing wheel hub assemblies is a process that can vary relative to the technician performing the procedure, but there are common mistakes made that can affect the outcome of the project. Avoid the aforementioned mistakes, and keep your customers’ vehicles performing well on the roadways.